1.25L EPG Epoxy Resin and Hardener 4.1

An ambient curing marine, laminating epoxy system for wet lay-up techniques in wooden boat fibreglassing. Two distinct hardeners, each combined with the one standard epoxy resin provide differing open time and cure periods for most working situations. BENEFITS: •Very low viscosity, high functionality, for superior wet out on timber, glass and exotic cloths • Low diluent levels in the resin ensure superior cured strengths • Can be combined with epoxy Glue Powder to form high strength epoxy glue • Can be combined with epoxy Fairing Powder to form an epoxy fairing compound USE FOR: Timber boat building. Also steel, aluminium and GRP Osmosis repair and barrier coating below the waterline As a construction epoxy glue Marine and construction coving (filleting) hole and gap filling Note : For a clear bright finish on timber, use EPG's CLR 2:1 system. The Fast (winter) hardener can be used during winter months, or when the ambient temperature is below 15°C. Not recommended for use below 8°C. The Slow (summer) hardener is for use when the ambient temperature is above 15°C. Ideally suited for use between 15°C - 25°C. Mixing ratio Resin Hardener Gel time (100gm mass) Fast (winter) system 100: 25 by volume 20minutes @ 15°C Slow (summer) system 100: 25 by volume 25 minutes @ 20°C Do not alter the ratios as both systems are optimised for this ratio. A weakening of all physical attributes will occur if altered. Will cover approximately two and a quarter square metres when used with 6oz (200gm) glass cloth. Will cover approximately six to seven square metres when applied without glass cloth. Note! : Never thin with epoxy solvent as this will remain in the cured film and weaken the coating.